pallet wood projects
2-3 colors of duct tape
Main color: MC
Liner color: LC
Trim color: TC
Start by cutting 6 1/2 inch strips of your MC. Keep overlapping pieces of tape until you have a strip that measures approximately 6 1/2 by 25 inches. Start by laying the first piece about 1/2 inch from the first piece of your MC, sticky sides together. Then trim the edges so the piece is 6 inches wide and 24 1/2 inches long.Next, make the side pieces. Lay your main piece and side pieces down with the lining side up. Measure 8 inches from the edge of the main piece and make a mark. Then, what you need to do is tape up the sides of the side pieces to the sides of the main piece. Cut an 8 inch piece of tape in the LC. Fold the edge of the main piece up, pushing it up against the other side of the tape connected to the side piece. Start by cutting 2 8 inch strips of your LC. Use them to tape up the side edges between the main piece and the side pieces. Then cut a 4 inch piece of LC and cut it in half lengthwise to tape up the bottom edges.
<iframe width="560" height="315" src="//www.youtube.com/embed/7T_520MXK24" frameborder="0" allowfullscreen></iframe>
2-3 colors of duct tape
Main color: MC
Liner color: LC
Trim color: TC
Start by cutting 6 1/2 inch strips of your MC. Keep overlapping pieces of tape until you have a strip that measures approximately 6 1/2 by 25 inches. Start by laying the first piece about 1/2 inch from the first piece of your MC, sticky sides together. Then trim the edges so the piece is 6 inches wide and 24 1/2 inches long.Next, make the side pieces. Lay your main piece and side pieces down with the lining side up. Measure 8 inches from the edge of the main piece and make a mark. Then, what you need to do is tape up the sides of the side pieces to the sides of the main piece. Cut an 8 inch piece of tape in the LC. Fold the edge of the main piece up, pushing it up against the other side of the tape connected to the side piece. Start by cutting 2 8 inch strips of your LC. Use them to tape up the side edges between the main piece and the side pieces. Then cut a 4 inch piece of LC and cut it in half lengthwise to tape up the bottom edges.
<iframe width="560" height="315" src="//www.youtube.com/embed/7T_520MXK24" frameborder="0" allowfullscreen></iframe>
No comments:
Post a Comment